Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › from 2017.10
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248348 SEAT BELT WARNING SYSTEM D

SEAT BELT  SEAT BELT WARNING SYSTEM  OPERATION CHECK  


INSPECT FRONT SEAT BELT WARNING LIGHT (DRIVER SIDE)


a.

Turn the ignition switch to ON.


b.

When the driver seat belt is not fastened without the front passenger seat occupied, check that the front seat belt warning light in the combination meter assembly blinks.


c.

When the driver seat belt is fastened, check that the front seat belt warning light in the combination meter turns off.



INSPECT FRONT SEAT BELT WARNING LIGHT (FRONT PASSENGER SIDE)


a.

Turn the ignition switch to ON.


b.

When the driver seat belt is fastened and the front passenger side seat belt is not fastened with the front passenger seat occupied, check that the front seat belt warning light in the combination meter assembly blinks.


c.

When the front seat belt is fastened with the front passenger seat occupied, check that the front seat belt warning light in the combination meter assembly turns off.



INSPECT REAR SEAT BELT WARNING LIGHT


a.

When rear door is opened and closed


b.

Turn the ignition switch to ON.


c.

When a rear seat belt is not fastened, check that the rear seat belt warning light on the telltale assembly is illuminated.


d.

After 34 seconds, check that the rear seat belt warning light on the telltale assembly turns off.


e.

When one of the rear seat belts is unfastened from being fastened, check that the rear seat belt warning light on the telltale assembly illuminates.



INSPECT SEAT BELT WARNING BUZZER


HINT:

If the buzzer does not sound, the buzzer cancel setting may be set to on (See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>CUSTOMIZE PARAMETERS).


a.

Lift up the vehicle using a swing arm type lift (See page General>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS).


b.

Turn the ignition switch to ON.


c.

Place a weight of 20 kg (44.0 lb) on the front passenger seat.

NOTICE:

Place the weight on the seat cushion and do not allow it to come into contact with the seatback.



d.

Open and close a front door (the front door courtesy light switch turns on and off).


e.

When the vehicle is driven at approximately 20 km/h (12.5 mph) or more while the driver or front passenger is not fastened, check that the buzzer in the combination meter sounds at an interval of 1.2 seconds for 30 seconds, and then sounds at an interval of 0.4 seconds for 90 seconds.


f.

Check that the buzzer stops 2 minutes after the buzzer starts sounding.


g.

After the buzzer stops, turn the ignition switch off and then start the engine again. Then drive the vehicle at approximately 20 km/h (12.5 mph) or more while the driver or front passenger seat belt is not fastened, and check that the buzzer sounds again.


h.

After the buzzer stops, fasten the driver and front passenger seat belts. Drive the vehicle at approximately 20 km/h (12.5 mph) or more and unfasten the driver or front passenger seat belt, and then check that the buzzer sounds again.


i.

After the buzzer stops, move the shift lever to R, and then move it to D. Drive the vehicle at approximately 20 km/h (12.5 mph) or more, and then check that the buzzer sounds again.