Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY(for RH Side) › from 2017.10
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248341 REAR SEAT INNER BELT ASSEMBLY(for RH Side) G

SEAT BELT  REAR SEAT INNER BELT ASSEMBLY(for RH Side)  INSPECTION  


PROCEDURE

Hide 73470B 1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH

a.
B222445C02
0.145,0 0.423,0.260 0.278,0.260 10 *a
*a Component without harness connected
(Rear seat inner with center belt assembly RH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 RH side tongue plate fastened 10 kΩ or higher
1 - 2 RH side tongue plate released Below 1 Ω


If the result is not as specified, replace the rear seat inner with center belt assembly RH.