Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › from 2017.10
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248423 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 83950M 1.INSPECT TELLTALE LAMP ASSEMBLY

a.

Check the resistance.

i.
E382204C01
1.156,1.667 1.458,1.281 true 1.604,1.01 1.271,0.583 true 1.01,1.625 1.167,1.823 0.156,0.198 10 false E 0.927,0.479 1.542,0.677 0.615,0.198 10 false ILL+ 0.135,0.146 0.448,0.344 0.313,0.198 10 false *a
*a Component without harness connected
(Telltale Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 8 (E) OFF 10 kΩ or higher
ON Below 1 Ω


If the result is not as specified, replace the telltale light assembly.



b.

Check that the illumination light.

i.

Apply battery voltage to the telltale light assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 8 (E)
Illuminates


If the result is not as specified, replace the telltale light assembly.