Home › Vehicle Interior › PRE-CRASH SAFETY › CAMERA HEATER › from 2018.06
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0359492 CAMERA HEATER A

PRE-CRASH SAFETY  CAMERA HEATER  INSTALLATION  


PROCEDURE

Hide 88185 1.INSTALL PRE-CRASH SAFETY CITY HEATER

HINT:
·

Perform this step only when replacement of the pre-crash safety city heater is necessary.

·

If a pre-crash safety city heater has been removed, replace it with a new one. Install a new pre-crash safety city heater with the pre-crash safety city heater wire as a set.

·

Be careful not to bend the pre-crash safety city heater as it may cause an open circuit. If the pre-crash safety city heater has been bent, make sure to replace it with a new one.

·

If the heater wire and adhesive and plastic outer layers of the pre-crash safety city heater have separated, make sure to replace the pre-crash safety city heater with a new one, otherwise water ingress may occur and cause a short circuit.



a.

Clean the windshield glass surface.


b.

If the ambient temperature is lower than 15°C:

i.

Using a heat light, heat the pre-crash safety city heater and windshield glass surface.

Heating Temperature
Item Temperature
Pre-crash safety city heater 15 to 80°C (59 to 176°F)
Windshield glass 15 to 80°C (59 to 176°F)

CAUTION:
·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the pre-crash safety city heater or windshield glass excessively.




c.
E401124C01
0.813,0.865 1.229,0.948 false 1.99,0.917 2.406,0.833 false 0.604,0.802 0.917,1 0.313,0.198 10 false *b 2.5,0.76 2.813,0.958 0.313,0.198 10 false *a
*a Terminal A
*b Terminal B


Connect the 2 connectors.

HINT:

Connect the connector to terminal as shown in the illustration.



d.

Remove the release paper from a new pre-crash safety city heater.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



e.

Align the pre-crash safety city heater with pre-crash safety city heater wire with the alignment marks and install it.

E357200C01
5.677,1.302 5.854,0.813 true 1.177,1.719 0.781,1.25 true 5.802,0.615 6.115,0.813 0.313,0.198 10 false *a 0.646,1.073 0.958,1.271 0.313,0.198 10 false *a
*a Alignment Mark - -


NOTICE:
·

Make sure to install the pre-crash safety city heater with pre-crash safety city heater wire within the black ceramic border of the windshield glass.

·

The double-sided tape of a pre-crash safety city heater will deteriorate if it is detached. Make sure to replace the pre-crash safety city heater with a new one when reattachment is necessary.



HINT:

Apply the pre-crash safety city heater along the bracket.



Hide 88186 2.INSTALL PRE-CRASH SAFETY CITY HEATER WIRE

a.

Engage the 2 guides and clamp to install the pre-crash safety city heater wire.


Hide 88181 3.INSTALL PRE-CRASH SAFETY CITY SENSOR