Home › Vehicle Interior › PRE-CRASH SAFETY › RELAY › from 2018.06
RM19S0E _58 Vehicle Interior _063185 PRE-CRASH SAFETY _0361034 RELAY G

PRE-CRASH SAFETY  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 88185A 1.INSPECT TSS C HTR RELAY

a.
A392070

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω
1 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
2 - 3 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher


If the result is not as specified, replace the TSS C HTR relay.