Home › General › SPECIFICATIONS › HEATING / AIR CONDITIONING › from 2017.01
RM19S0E _V1 General _051446 SPECIFICATIONS _0248022 HEATING / AIR CONDITIONING F

SPECIFICATIONS  HEATING / AIR CONDITIONING  TORQUE SPECIFICATIONS  


Part Tightened N*m kgf*cm ft.*lbf
Cooler expansion valve x No. 1 cooler evaporator sub-assembly 3.5 36 31 in.*lbf
No. 1 air duct assembly x Body 9.8 100 87 in.*lbf
Air conditioning unit x Instrument panel reinforcement (for bolt) 9.8 100 87 in.*lbf
Air conditioning unit x Instrument panel reinforcement (for nut) 4.0 41 35 in.*lbf
Air conditioning unit x Instrument panel reinforcement (for screw) 4.0 41 35 in.*lbf
Ground wire x Instrument panel reinforcement 8.4 86 74 in.*lbf
Connector holder x Body 8.4 86 74 in.*lbf
PTC heater wire x Instrument panel brace sub-assembly 8.4 86 74 in.*lbf
Instrument panel junction block assembly x Wiring harness clamp bracket 8.4 86 74 in.*lbf
Suction tube sub-assembly x No. 1 cooler evaporator sub-assembly 9.8 100 87 in.*lbf
Compressor with pulley assembly x Oil pan sub-assembly 25 250 18
No. 1 cooler refrigerant discharge hose x Compressor with pulley assembly 9.8 100 87 in.*lbf
Suction hose sub-assembly x Compressor with pulley assembly 9.8 100 87 in.*lbf
Cooler dryer x Cooler condenser assembly 2.9 30 26 in.*lbf
Radiator upper support sub-assembly x Radiator support sub-assembly LH 5.4 55 48 in.*lbf
Radiator upper support sub-assembly x Radiator support sub-assembly RH 5.4 55 48 in.*lbf
Air conditioner pressure sensor x Liquid tube sub-assembly A 11 110 8
Negative battery terminal x Battery 5.4 55 48 in.*lbf