86160B
1.INSPECT REAR SPEAKER ASSEMBLY (for Type A)
Check the speaker installation.
The speaker is securely installed.
Visually check the speaker.
The cone paper of the speaker is not torn.
Check the speaker resistance.
| *a | Component without harness connected
(Rear Speaker Assembly) |
Disconnect the rear speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | Approximately 4 Ω |
If the result is not as specified, replace the rear speaker assembly.
86160B
2.INSPECT REAR SPEAKER ASSEMBLY (for Type B)
Check the resistance.
| *a | Component without harness connected
(Rear Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (+) - 1 (-) | Always | 4.0 Ω |
If the result is not as specified, replace the rear speaker assembly.
Visually check the speaker.
The cone paper of the rear speaker assembly is not torn.
If the result is not as specified, replace the rear speaker assembly.