Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM (for Sedan)

TIRE AND WHEEL SYSTEM (for Sedan) > INSPECTION



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Vehicle Speed
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    185/60R15 84H
    Driving below
    160 km/h (100 mph)
    220 (2.2, 32)
    220 (2.2, 32)
    Driving above
    160 km/h (100 mph)
    230 (2.3, 33)
    230 (2.3, 33)



    C164558
  1. Using a dial indicator, check the tire runout.

    Tire Runout:
    Vertical
    1.4 mm (0.0551 in.) or less
    Lateral
    2.0 mm (0.0787 in.) or less



2. ROTATE TIRES


R014931E09

HINT:
Rotate the tires, as shown in the illustration.

Text in Illustration 
V100136
Front of the Vehicle

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. INSPECT WHEEL BALANCE


    C286974E01
  1. Inspect and adjust the off-the-car balance.

    Maximum imbalance:
    8.0 g (0.0176 lb)

    NOTICE:
    1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
    2. Do not touch the adhesive part of the tape.
    3. Adhere the sticking type balance weight to the flat surface (A) shown in the illustration.

      Width (A):
      25 mm (0.984 in.)

    4. Push the balance weight securely with a finger to adhere it to the position.
    5. Do not reuse the balance weight.
    6. Use the TOYOTA genuine sticking type balance weights.

    HINT:
    The inner side balance weight should be installed by clipping it to the rim.

  1. If required, inspect and adjust the on-the-car balance.

    Maximum imbalance:
    8.0 g (0.0176 lb)



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)