DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | Open in ETCS (Electronic Throttle Control System) power source (+BM) circuit (1 trip detection logic) |
|

| 1.READ VALUE USING TECHSTREAM (+BM VOLTAGE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / +BM Voltage.
Read the value displayed on the Techstream.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room relay block.
Disconnect the A21 ECM connector.
Check the resistance.
| Tester Connections | Specified Conditions |
| ETCS fuse (2) - +BM (A21-3) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| ETCS fuse (2) or +BM (A21-3) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the ECM connector.
Check the harness and connector between the ETCS fuse and positive battery cable.
Remove the ETCS fuse from the engine room relay block.
Disconnect the cable from the negative battery terminal.
Disconnect the cable from the positive battery terminal.
Check the resistance.
| Tester Connections | Specified Conditions |
| Positive battery cable - ETCS fuse (1) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| Positive battery cable or ETCS fuse (1) - Body ground | 10 kΩ or higher |
Reinstall the ETCS fuse.
Reconnect the cable to the positive battery terminal.
Reconnect the cable to the negative battery terminal.
|
| ||||
| OK | |
| 3.INSPECT ECM (+BM TERMINAL VOLTAGE) |
![]() |
Disconnect the A21 and C20 ECM connectors.
Measure the voltage between the terminals of the A21 and C20 ECM connectors.
| Tester Connections | Specified Conditions |
| +BM (A21-3) - E1 (C20-104) | 11 to 14 V |
| +BM (A21-3) - ME01 (C20-43) | 11 to 14 V |
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||