DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0125 | The engine coolant temperature does not reach the closed loop enabling temperature for 20 minutes (this period varies with the engine coolant temperature at engine start) (2 trip detection logic). |
|
| Related DTCs | P0125: Insufficient Engine Coolant Temperature for Closed Loop Fuel Control |
| Required Sensors/Components (Main) | Engine coolant temperature sensor Thermostat Cooling system |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 59 seconds: Engine coolant temperature at engine start is (closed loop engine coolant temperature - 8.33°C [17°F]) or higher 108 seconds: Engine coolant temperature at engine start is (closed loop engine coolant temperature - 19.44°C [-3°F]) or higher, and less than (closed loop engine coolant temperature - 8.33°C [17°F]) 1200 seconds: Engine coolant temperature at engine start is less than (closed loop engine coolant temperature - 19.44°C [-3°F]) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Thermostat fail (P0128) | Not detected |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118) | Not detected |
| Mass air flow meter sensor circuit fail (P0101, P0102, P0103) | Not detected |
| Time until actual engine coolant temperature reaches closed loop fuel control enabling temperature | 59 seconds: Engine coolant temperature at engine start is (closed loop engine coolant temperature - 8.33°C [17°F]) or higher 108 seconds: Engine coolant temperature at engine start is (closed loop engine coolant temperature - 19.44°C [-3°F]) or higher, and less than (closed loop engine coolant temperature - 8.33°C [17°F]) 1200 seconds: Engine coolant temperature at engine start is less than (closed loop engine coolant temperature - 19.44°C [-3°F]) |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P0125 is output | A |
| DTC P0125 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT THERMOSTAT |
Inspect the thermostat (thermostat opening temperature) (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.
|
| ||||
| OK | ||
| ||