STEERING PAD (for Hatchback) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the lower No. 2 steering wheel cover.
| *1 | Protective Tape |
| 4. REMOVE STEERING PAD |
![]() |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Using a "TORX" driver, push in the 3 snap rings to disengage it from the 3 pins.
Pull the steering pad toward rear.
Using a screwdriver with its tip wrapped with protective tape, release the 2 locking buttons.
![]() |
Disconnect the 2 airbag connectors.
| *1 | Protective Tape |
| *2 | Locking button |
Disconnect the horn terminal.