Home › General › INTRODUCTION › REPAIR INSTRUCTION (for Hatchback)

REPAIR INSTRUCTION (for Hatchback) > INITIALIZATION



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
See Page
ECM
Vehicle Identification Number (VIN) registration
DTC P0630 is output
Click here
ECU communication ID registration
(Engine immobiliser system)
Engine starting
Click here
  1. Throttle with motor body assembly or any throttle body components
  2. Throttle body is cleaned
  3. Engine assembly
  4. Cylinder head
  5. Camshaft (for intake side)
  6. Camshaft timing gear assembly
  7. Piston or piston ring
  8. Mass air flow meter
  9. Fuel injector assembly
  10. Fuel pump
  11. Air fuel ratio sensor
  12. Engine coolant temperature sensor
  13. Spark plug
  14. No.1 ignition coil
  15. Knock sensor
  16. Air leaks from intake system
  17. Gas leaks from exhaust system
Inspection after repairs
-
Click here
Automatic transaxle assembly, engine assembly or ECM
  1. Road test
  2. Reset memory
Large shift shock
Click here
  1. Door control and tire pressure monitoring system receiver assembly*1
  2. Tire pressure monitor receiver assembly*2
Register transmitter IDs
  1. When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates
  2. Tire pressure monitoring function
Click here for Initialization
Click here for Registration
Tire pressure warning valve and transmitter
Click here
Yaw rate and deceleration sensor (Airbag sensor assembly)
  1. Clearing zero point calibration data
  2. Yaw rate and deceleration sensor zero point calibration
VSC control is prohibited or operation is incorrect
Click here
Skid control ECU
(Brake actuator assembly)
Yaw rate and deceleration sensor zero point calibration
VSC control is prohibited or operation is incorrect
Click here
Front wheel alignment
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
VSC control is prohibited or operation is incorrect
Click here
  1. Power steering ECU
  2. Power steering column sub-assembly
  3. Power steering motor
  4. Steering wheel
  5. Steering gear assembly
Perform rotation angle sensor initialization and torque sensor zero point calibration
  1. Power steering warning light comes on
  2. EPS control
Click here
  1. Door control and tire pressure monitoring system receiver assembly*3
  2. Door control receiver*4
  3. Key
Code registration
Wireless door lock control system
Click here
  1. Transponder key ECU
  2. Key
ECU communication ID registration
(Engine immobiliser system)
Engine starting
Click here
  1. Occupant classification ECU
  2. Accessories (seatback tray and seat cover, etc.) are installed
  3. Front passenger seat is removed from the vehicle
  4. Vehicle is brought to the workshop for repair due to an accident or a collision
  1. Perform zero point calibration
  2. Sensitivity check
  1. Occupant classification system
  2. Airbag system (Front passenger side)
  3. Seat belt warning system (Front passenger side)
Click here
  1. *1: w/ Wireless Door Lock Control System
  2. *2: w/o Wireless Door Lock Control System
  3. *3: w/ Tire Pressure Warning System
  4. *4: w/o Tire Pressure Warning System