Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE (for Sedan)

SPIRAL CABLE (for Sedan) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE STEERING PAD


C137495
  1. Using "TORX" socket wrench T30, loosen the 2 bolts completely.

  1. Pull the steering pad toward you.



    C137496E01
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, disconnect the 2 airbag connectors.

  1. Detach the horn connector.



3. REMOVE STEERING WHEEL ASSEMBLY


    C139086E01
  1. Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.



    C139087
  1. Using SST, remove the steering wheel assembly.

    NOTICE:
    Apply a small amount of grease to the threads and tip of the SST center bolt before using.



4. REMOVE STEERING COLUMN COVER


C139120
  1. Remove the 3 screws.

  1. Disengage the 2 claws and remove the steering column cover (lower).

  1. Disengage the 2 claws and remove the steering column cover (upper).



5. REMOVE SPIRAL CABLE


B108276E01
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.



    C121531
  1. Disengage the 3 claws and remove the spiral cable.