DTC B1451 Compressor Solenoid Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1451 | An open or short in the cooler compressor solenoid circuit. |
|

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Regulator Control Current | Regulator control current / Min.: 0 A Max.: 0.997 A | Value changes between 0.12 A and 0.997 A in accordance with compressor operation | - |
| Result | Proceed to |
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMPRESSOR WITH PULLEY ASSEMBLY |
Inspect the compressor with pulley assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY) |
Disconnect the C64 compressor with pulley assembly connector.
Disconnect the D130 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C64-2 (SOL+) - D130-11 (SOL+) | Always | Below 1 Ω |
| C64-2 (SOL+) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the C64 compressor with pulley assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C64-1 (SOL-) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Compressor with Pulley Assembly) |
|
| ||||
| OK | ||
| ||