DTC P0443 Evaporative Emission Control System Purge Control Valve Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0443 | Terminal voltage of ECM output circuit does not correspond with drive signals from ECM to purge VSV (1 trip detection logic) |
|

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (ACTIVATE THE VSV FOR EVAP CONTROL) |
![]() |
Connect the Techstream to the DLC3.
Disconnect the vacuum hose (canister side) from the purge VSV.
Start the engine.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.
When the purge VSV is operated using the Techstream, check whether the port of the purge VSV applies suction to your finger.
| Tester Operations | Specified Conditions |
| VSV ON | Purge VSV port applies suction to finger |
| VSV OFF | Purge VSV port applies no suction to finger |
Reconnect the vacuum hose to the purge VSV.
|
| ||||
| OK | ||
| ||
| 2.INSPECT PURGE VSV (RESISTANCE) |
![]() |
Disconnect C3 purge VSV connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Specified Conditions |
| 1 - 2 | 23 to 26 Ω at 20°C (68°F) |
Reconnect the purge VSV connector.
|
| ||||
| OK | |
| 3.INSPECT PURGE VSV (POWER SOURCE) |
![]() |
Disconnect the C3 purge VSV connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connections | Specified Conditions |
| C3-2 - Body ground | 11 to 14 V |
Reconnect the purge VSV connector.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (PURGE VSV - ECM) |
![]() |
Disconnect the C3 purge VSV connector.
Disconnect the C20 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Specified Conditions |
| C3-1 - C20-49 (PRG) | Below 1 Ω |
| Tester Connections | Specified Conditions |
| C3-1 or C20-49 (PRG) - Body ground | 10 kΩ or higher |
Reconnect the purge VSV connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (PURGE VSV - INTEGRATION RELAY) |
![]() |
Disconnect the C3 purge VSV connector.
Remove the integration relay from the engine room relay block.
Check the resistance.
| Tester Connections | Specified Conditions |
| C3-2 - 1A-4 | Below 1 Ω |
| Tester Connections | Specified Conditions |
| C3-2 or 1A-4 - Body ground | 10 kΩ or higher |
Reconnect the purge VSV connector.
Reinstall the integration relay.
|
| ||||
| OK | ||
| ||