DTC P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0756 | S2 stuck OFF malfunction*1: Shifting to 1st and 4th gears is impossible. ECM determines that there is malfunction when all of following conditions are met (2-trip detection logic). (a) When ECM directs gearshift to switch to 1st gear, actual gear is shifted to 2nd. (b) When ECM directs gearshift to switch to 3rd gear, actual gear is shifted to 3rd. (c) When ECM directs gearshift to switch to 4th gear, actual gear is shifted to 3rd. |
|
| S2 stuck ON malfunction*2: Shifting to 2nd gear and 3rd gear is impossible. ECM determines that there is malfunction when all of following conditions are met (2-trip detection logic). (a) When ECM directs gearshift to switch to 2nd gear, actual gear is shifted to 1st. (b) When ECM directs gearshift to switch to 3rd gear, actual gear is shifted to 4th. (c) When ECM directs gearshift to switch to 4th gear, actual gear is shifted to 4th. |
|
| Gearshift controlled by ECM | 1st | 2nd | 3rd | 4th |
| *1: Actual gear position under S2 stuck OFF malfunction | 2nd | 2nd | 3rd | 3rd |
| *2: Actual gear position under S2 stuck ON malfunction | 1st | 1st | 4th | 4th |
| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
In accordance with the display on the Techstream, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the Shift Position | [Test Details] Operate shift solenoid valve and set each shift position. [Others]
| 1st/2nd/3rd/4th | Possible to check operation of shift solenoid valves. [Vehicle Condition]
|
| Gearshift controlled by ECM | 1st | 2nd | 3rd | 4th |
| Shift solenoid valve S2 | ON | OFF | OFF | ON |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0756) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Result | Proceed to |
| Only P0756 is output | A |
| P0756 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE S2 |
![]() |
Remove shift solenoid valve S2.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - Solenoid Body | 20°C (68°F) | 11 to 15 Ω |
Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.
| *a | Component without harness connected (Shift Solenoid Valve S2) |
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
|
| ||||
| OK | ||
| ||