Home › Engine / Hybrid System › 1NZ-FE STARTING › IGNITION SWITCH (for Hatchback)

IGNITION SWITCH (for Hatchback) > INSTALLATION



1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY

NOTICE:
  1. Perform the operation after situating the upper steering column bracket assembly in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.
  2. Do not turn the upper steering column bracket assembly sideways or downward because doing so might release the upper steering column bracket assembly's component parts.

  1. Engage the 2 claws and install the ignition or starter switch assembly.

  1. Connect the connector.



2. INSTALL STEERING COLUMN ASSEMBLY
(Click here)