FRONT EVAPORATOR TEMPERATURE SENSOR (for Sedan) > REMOVAL |
| 1. REMOVE AIR CONDITIONING UNIT |
| 2. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a hexagon wrench 4, remove the 2 hexagon bolts and detach the cooler expansion valve.
Remove the 2 O-rings from the No. 1 cooler evaporator.
| 3. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Disengage the cooler thermistor connector.
![]() |
Remove the 3 screws.
Disengage the 4 claws and remove the heater case lower.
![]() |
Remove the cooler evaporator.
| 4. REMOVE NO. 1 COOLER THERMISTOR |
![]() |
Remove the No. 1 cooler thermistor from the cooler evaporator.