DTC P0504 Brake Switch "A" / "B" Correlation |
| Signal (ECM Terminal) | Brake Pedal Released | In Transition | Brake Pedal Depressed |
| STP | OFF | ON | ON |
| ST1- | ON | ON | OFF |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0504 | Conditions (a), (b) and (c) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch ON (b) Brake pedal released (c) STP signal OFF when ST1- signal OFF |
|

| Brake Pedal Operation | Stop Light Switch | ST1 |
| Depressed | ON | ON |
| Released | OFF | OFF |
| 1.INSPECT STOP LIGHT SWITCH ASSEMBLY (POWER SOURCE VOLTAGE) |
![]() |
Disconnect the stop light switch assembly connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A65-2 - Body ground | Always | 11 to 14 V |
| A65-4 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Stop Light Switch Assembly) |
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 3.INSPECT ECM (STP AND ST1 - VOLTAGE) |
![]() |
Disconnect the ECM connector.
| *a | Brake Pedal Depressed |
| *b | Brake Pedal released |
| *c | Front view of wire harness connector (to ECM) |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Operation | Specified Condition |
| A72-10 (ST1-) - Body ground | Released | 11 to 14 V |
| Depressed | Below 1.5 V | |
| A72-9 (STP) - Body ground | Released | Below 1.5 V |
| Depressed | 11 to 14 V |
|
| ||||
| OK | ||
| ||