AIRBAG SYSTEM (for Sedan) > DTC CHECK / CLEAR |
| CHECK DTC (Using SST Check Wire) |
![]() |
Check for DTCs (Present DTC).
Turn the ignition switch on, and wait for approximately 60 seconds.
Using SST, connect terminals TC and CG of the DLC3.
Check for DTCs (Past DTC).
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch on, and wait for approximately 60 seconds.
![]() |
Read the DTCs.
Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and DTCs 11 and 31 are shown in the illustration on the left.
| CLEAR DTC (Using SST Check Wire) |
Clear the DTCs.
When the ignition switch is turned off (turned to the lock position), the DTCs are cleared.
Using SST, connect terminals TC and CG of the DLC3, and then turn the ignition switch on.
Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output, and check that the SRS warning light comes on after 3 seconds.
Within 2 to 4 seconds of the SRS warning light coming on, connect terminals TC and CG of the DLC3.
The SRS warning light goes off within 2 to 4 seconds of connecting terminals TC and CG of the DLC3. Then, disconnect terminal TC within 2 to 4 seconds of the SRS warning light going off.
The SRS warning light comes on again within 2 to 4 seconds of disconnecting terminal TC. Then, reconnect terminals TC and CG within 2 to 4 seconds of the SRS warning light coming on.
Check that the SRS warning light goes off within 2 to 4 seconds of connecting terminals TC and CG of the DLC3. Also check that the normal system code is output within 1 second of the SRS warning light going off.
If DTCs are not cleared, repeat these procedure until the DTCs are cleared.

| CHECK DTC (Using Techstream) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes /
| CLEAR DTC (Using Techstream) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes /
Erase the DTCs.