AIRBAG SYSTEM (for Sedan) > TC and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM) |
![]() |
Turn the ignition switch off.
Disconnect the connector from the ECM.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| D15-13 (TC) - A21-27 (TC) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND) |
![]() |
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| D15-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TC OF ECM) |
![]() |
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| A21-27 (TC) - Body ground | Always | 1 MΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM.
Check for DTCs of the ECM (Click here ).
| Result | Proceed to |
| Normal system code is output | A |
| DTC is output | B |
| DTC output mode is set (except center airbag sensor assembly) | C |
|
| ||||
|
| ||||
| C | ||
| ||