DTC C1427 Motor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1427 | Actuator pump motor does not operate properly. |
|
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (ABS MOTOR RELAY) |
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Clear the DTC (Click here).
Enter the following menu: Chassis / ABS/VSC/TRAC / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor can be heard. |
Check the operating sound of the ABS motor relay when operating it with the Techstream.
| Result | Proceed to |
| The operating sound is not heard | A |
| The operating sound is heard | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A71-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid control ECU) |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1427 is not output | A |
| DTC C1427 is output | B |
|
| ||||
| A | ||
| ||