TIRE PRESSURE WARNING SYSTEM (for Hatchback) > REGISTRATION |
| 1. BEFORE REGISTRATION |
In case of tire pressure warning ECU and receiver replacement:
Read the registered transmitter IDs that are stored in the old ECU using the Techstream and note them down.
If reading the stored transmitter IDs is impossible due to malfunctions of components such as the tire pressure warning ECU and receiver, remove the tires from the wheels and check the IDs located on the tire pressure warning valve and transmitters.
In case of tire pressure warning valve and transmitter replacement:
Take a note of the 7 digit number (transmitter ID) written on the tire pressure warning valve and transmitter.

| *1 | Tire Pressure Warning Valve and Transmitter | *2 | Transmitter ID (7 Digit Number) |
| 2. REGISTER TRANSMITTER ID (USING THE TECHSTREAM) |
Set the air pressure of all tires to the specified value(s) (Click here).
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
Perform the procedure displayed on the Techstream.
| 3. CONFIRMATION OF TRANSMITTER ID REGISTRATION |
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Confirm that the tire pressure data of all tires (except the spare tire) is displayed on the Techstream screen.