DTC C1241 Low Power Supply Voltage Malfunction |
| DTC NO. | DTC Detection Condition | Trouble Area |
| C1241 | When any of the following is detected:
|
|

| 1.INSPECT BATTERY |
Inspect the battery voltage.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG1 TERMINAL) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the A15 brake actuator assembly (skid control ECU) connector.
Check the connector case and terminals for deformation and corrosion.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A15-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GND1, GND2 TERMINAL) |
Turn the ignition switch off.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-1 (GND1) - Body ground | Always | Below 1 Ω |
| A15-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Brake Actuator Assembly (Skid Control ECU)) |
Reconnect the A15 brake actuator assembly (skid control ECU) connector.
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||