Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (for Hatchback)

WIRELESS DOOR LOCK CONTROL SYSTEM (for Hatchback) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock system is operating normally. Check the power door lock system first before troubleshooting the wireless door lock control system.
  2. Use this procedure to troubleshoot the wireless door lock control system.
  3. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Check the battery voltage.

    2. Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List / Active Test (Click here).

    3. Operation Check (Click here).


    NEXT


    6.REPAIR OR REPLACE

      HINT:
      Register the recognition code when replacing the door control transmitter or the door control receiver.


    NEXT


    7.CONFIRMATION TEST

      NEXT

      END