Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER (for Sedan)

CONDENSER (for Sedan) > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    I106447E01
  1. Remove the caps from the service valves on the refrigerant line.

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE FRONT BUMPER COVER
(Click here)


3. REMOVE NO. 1 COOLER COVER


A109229
  1. Remove the 2 clips and No. 1 cooler cover.



4. SEPARATE HOOD LOCK ASSEMBLY (w/ Theft Deterrent System)


A108455
  1. Separate the hood lock control cable assembly from the 2 clamps.



    A117345
  1. Separate the engine hood courtesy switch connector.

  1. Remove the 3 bolts and remove the hood lock assembly.



5. SEPARATE HOOD LOCK ASSEMBLY (w/o Theft Deterrent System)


A108455
  1. Separate the hood lock control cable assembly from the 2 clamps.



    A108456
  1. Remove the 3 bolts and remove the hood lock assembly.



6. REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER


A255858
  1. Separate the horn assembly connector.

  1. Remove the 4 bolts and remove the radiator support sub-assembly upper.



7. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


I102630
  1. Remove the bolt and disconnect the discharge hose from the cooler condenser.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



8. DISCONNECT LIQUID TUBE SUB-ASSEMBLY A


I102631
  1. Remove the bolt and disconnect the liquid tube from the cooler condenser.

  1. Remove the O-ring from the liquid tube.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



9. REMOVE CONDENSER


I102579
  1. Disengage the 2 claws and remove the condenser from the vehicle.

    NOTICE:
    Do not damage the condenser or radiator when removing the condenser.