AIRBAG SYSTEM (for Sedan) > SRS Warning Light Remains ON |

| 1.CHECK DTC (CAN COMMUNICATION SYSTEM) |
Turn the ignition switch to the on position.
Check the DTCs (Click here).
|
| ||||
| OK | |
| 2.CHECK BATTERY |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 3.CHECK CONNECTION OF CONNECTORS |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor assembly and combination meter.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF CENTER AIRBAG SENSOR ASSEMBLY) |
![]() |
Disconnect the connectors from the center airbag sensor assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on.
Operate all components of the electrical system (defogger, wipers, headlights, heater blower, etc.).
Measure the voltage.
| Tester Connection | Switch Condition | Specified Condition |
| D16-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
Turn the ignition switch off.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| D16-25 (E1) - Body ground | Always | Below 1 Ω |
| D16-26 (E2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER) |
![]() |
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect the connector from the combination meter.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on.
Measure the voltage.
| Tester Connection | Switch Condition | Specified Condition |
| D1-1 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
Turn the ignition switch off.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| D1-24 (ET) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK SRS WARNING LIGHT |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||