AIRBAG SYSTEM (for Sedan) > SRS Warning Light does not Come ON |
| 1.CHECK BATTERY |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 2.CHECK CONNECTION OF CONNECTORS |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor assembly and the combination meter.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER) |
![]() |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect the connectors from the combination meter and center airbag sensor assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on.
Measure the voltage.
| Tester Connection | Switch Condition | Specified Condition |
| D1-1 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| D1-2 (B) - Body ground | Always | 11 to 14 V |
Turn the ignition switch off.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| D1-24 (ET) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK SRS WARNING LIGHT |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch on.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||