DTC U0073 Control Module Communication Bus OFF |
DTC U0142 Lost Communication with Main Body ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0073 | When any of the following is detected:
| CAN communication system |
| U0142 | No communication with main body ECU | CAN communication system Main body ECU |
| 1.CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the Techstream, check for any momentary interruption in the wire harness and connector corresponding to a DTC (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| EFI Communication Open | EFI communication open detection / Normal or Error | Normal: Normal Error: Momentary interruption | - |
| Body ECU Communication Open | Body ECU open detection / Normal or Error | Normal: Normal Error: Momentary interruption | - |
| Result | Proceed to |
| There is a constant open circuit | A |
| There are no momentary interruptions | B |
| There are momentary interruptions | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK IF EACH SENSOR AND ECM CONNECTOR IS SECURELY CONNECTED |
Turn the ignition switch off.
Check if each sensor or ECM connector is securely connected.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Record the output DTCs (for ABS, VSC, and CAN communication) (Click here).
| Result | Proceed to |
| DTC (relating to CAN communication system) is output | A |
| DTC (relating to ABS and/or VSC system) is output | B |
| DTC is not output | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 4.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Turn the ignition switch off.
Repair or replace the harness or connector.
Check for any momentary interruption between the skid control ECU (brake actuator assembly) and each sensor or ECM (Click here).
Check that there is no momentary interruption.
| NEXT | |
| 5.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 15 km/h (9 mph) or more.
Check that no CAN communication system DTC is output (Click here).
If ABS and VSC DTCs are output, record them.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (relating to ABS and/or VSC system) | B |
| DTC is output (relating to CAN communication system) | C |
|
| ||||
|
| ||||
| A | ||
| ||