Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM (for Hatchback)

LIGHTING SYSTEM (for Hatchback) > High Beam Headlight Circuit


DESCRIPTION

The main body ECU controls the high beam headlights.

WIRING DIAGRAM


E231982E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Head Light Hi
    Headlight dimmer relay
    OFF or ON
    -

    OK:
    Headlight dimmer relay operates (High beam headlight illuminate.)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT HEADLIGHT DIMMER RELAY (DIM RELAY)
  1. Inspect the headlight dimmer relay (DIM relay) (Click here).



NG
REPLACE HEADLIGHT DIMMER RELAY (DIM RELAY)
OK


3.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER RELAY - BATTERY)


    E229352E01
  1. Remove the headlight dimmer relay (DIM relay) from the No. 2 engine room relay block.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    DIM-2 - Body ground
    Always
    11 to 14 V
    DIM-3 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *1
    No. 2 Engine Room Relay Block
    *2
    Headlight Dimmer Relay (DIM Relay) Holder



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER RELAY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
  1. Remove the headlight dimmer relay (DIM relay) from the No. 2 engine room relay block.

  1. Disconnect the 3C instrument panel junction block assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    DIM-1 - 3C-35
    Always
    Below 1 Ω
    DIM-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly.

  1. Remove the main body ECU from the instrument panel junction block assembly.



  1. Measure the resistance according to the value(s) in the table below.


    E231963E02


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3C-35 - MB-22 (DIM)
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)