KEY REMINDER WARNING SYSTEM (for Sedan) > Key Reminder Buzzer does not Sound |

| 1.READ VALUE USING TECHSTREAM |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on tester, read on the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Unlock Warning SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on tester, read on the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver side door courtesy switch signal / ON or OFF | ON: Driver side door is open OFF: Driver side door is closed | - |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER ASSEMBLY (WARNING BUZZER) |
Temporarily replace the combination meter assembly with a new or normally functioning one.
Check the key reminder warning system function. (Click here)
|
| ||||
| OK | ||
| ||
| 4.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch assembly.
Measure the resistance.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩor higher |
| 1 - 2 | Pushed | Below 1 Ω |
Reinstall the unlock warning switch assembly.
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - MAIN BODY ECU) |
![]() |
Disconnect the D19 unlock warning switch connector.
Disconnect the 4D main body ECU connector.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| D19-1 - 4D-7 (KSW) | Below 1 Ω |
| D19-1 or 4D-7 (KSW) - Body ground | 10 kΩor higher |
| D19-2 - Body ground | Below 1 Ω |
Reconnect the unlock warning switch and the main body ECU connectors.
|
| ||||
| OK | ||
| ||
| 6.INSPECT FRONT DOOR COURTESY SWITCH (DRIVER SIDE) |
![]() |
Remove the front door courtesy switch (driver side).
Measure the resistance of the switch.
| Tester Connection | Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| 1 - Body ground | Pushed (OFF) | 10 kΩor higher |
Reinstall the front door courtesy switch.
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY SWITCH - MAIN BODY ECU) |
![]() |
Disconnect the J2 front door courtesy switch connector.
Disconnect the 4A main body ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| J2-1 - 4A-21 (DCTY) | Below 1 Ω |
| J2-1 or 4A-21 (DCTY) - Body ground | 10 kΩor higher |
Reconnect the front door courtesy switch and main body ECU connectors.
|
| ||||
| OK | ||
| ||