Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (for Hatchback)

THEFT DETERRENT SYSTEM (for Hatchback) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.SYMPTOM SIMULATION

      NEXT


      4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
      1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

        Result:
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result:
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B



      B.
      Go to step 7
      A


      6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM*
      1. System Description (Click here).

      2. Terminals of ECU (Click here).

      3. Data List / Active Test (Click here).



      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END