LIGHTING SYSTEM (for Hatchback) > Hazard Warning Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hazard Flasher Switch | Hazard warning signal switch / OFF or ON | OFF: Hazard warning signal switch off ON: Hazard warning signal switch on | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY) |
![]() |
Disconnect the D101 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D101-1 (B) - Body Ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TELLTALE LIGHT ASSEMBLY (HAZARD WARNING SIGNAL SWITCH) - COMBINATION METER ASSEMBLY) |
Disconnect the D115 telltale light assembly (hazard warning signal switch) connector.
Disconnect the D101 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D115-4 (TB) - D101-3 (HAZ) | Always | Below 1 Ω |
| D115-5 (E) - Body Ground | Always | Below 1 Ω |
| D115-4 (TB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE TELLTALE LIGHT ASSEMBLY (HAZARD WARNING SIGNAL SWITCH) |
Replace the telltale light assembly (hazard warning signal switch) (Click here).
| NEXT | |
| 5.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hazard Flasher Switch | Hazard warning signal switch / OFF or ON | OFF: Hazard warning signal switch off ON: Hazard warning signal switch on | - |
|
| ||||
| OK | ||
| ||