SEAT POSITION SENSOR (for Sedan) > INSTALLATION |
| 1. INSTALL SEAT POSITION AIRBAG SENSOR |
Check that the ignition switch is turned to OFF.
Check that the battery negative (-) terminal is disconnected.
![]() |
Using an 1 mm (0.039 in.) feeler gauge, install the seat position airbag sensor.
Using "Torx" socket wrench, tighten the torx screw to install the seat position airbag sensor.
Make sure that a clearance between the seat position airbag sensor and the seat rail is within 0.6 mm (0.023 in.) to 2 mm (0.079 in.).
Connect the connector to the seat position airbag sensor.
Check that there is no looseness in the installation parts of the seat position airbag sensor.
| 2. INSTALL SEAT SLIDE POSITION SENSOR PROTECTOR |
![]() |
Engage the pin and install a new seat position sensor protector.
| 3. INSTALL FRONT SEAT ASSEMBLY LH |
![]() |
Insert the 2 locating pins through the 2 body holes, place the front seat in the most forward position, and then make sure that the inner and outer seat tracks are locked securely.
Using "TORX" socket wrench E10,Using an E10 "TORX" socket wrench, tighten bolt 1 and then bolt 2 on the rear side.
Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are locked securely.
Using an E10 "TORX" socket wrench, tighten bolt 3 and then bolt 4 on the front side.
Connect the buckle switch connector.
| 4. INSTALL FRONT SEAT HEADREST ASSEMBLY |
Push in the lock button of the front seat headrest support and install the front seat headrest.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. INSPECT SRS WARNING LIGHT |