Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (for Sedan)

THEFT DETERRENT SYSTEM (for Sedan) > ECU Power Source Circuit


DESCRIPTION

This circuit provides power to operate the theft warning ECU.

WIRING DIAGRAM


B122661E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B, DOME)
  1. Remove the ECU-B fuse and DOME fuse from the engine room R/B.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the fuses.



NG
REPLACE FUSE
OK


2.INSPECT THEFT WARNING ECU ASSEMBLY


    B122662E01
  1. Remove the theft warning ECU assembly without disconnecting the D26 connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Specified Condition
    D26-11 (+B1) - D26-16 (E)
    11 to 14 V
    D26-13 (+B2) - D26-16 (E)
    11 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3.CHECK HARNESS AND CONNECTOR (POWER SOURCE)


    B121327E09
  1. Disconnect the D26 theft warning ECU connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Specified Condition
    D26-11 (+B1) - Body ground
    11 to 14 V
    D26-13 (+B2) - Body ground
    11 to 14 V

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    D26-16 (E) - Body ground
    Below 1 Ω

  1. Reconnect the theft warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY (Click here)