THEFT DETERRENT SYSTEM (for Sedan) > Ignition Switch Circuit |

| 1.CHECK FOR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Clear the DTCs.
Check whether DTC B1269 recurs 10 seconds or more after the ignition switch is turned on.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (IGNITION SWITCH) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester main switch ON.
Select the item below in the Data List and read the display on Techstream.
| Item | Measurement Item/Display (Range) | Normal Condition | Diagnostic Note |
| IG SW | Ignition switch signal ON/OFF | ON: Key is in ON or START position OFF: Key is in LOCK or ACC position | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT FUSE (ECU-IG) |
![]() |
Remove the ECU-IG fuse from the main body ECU.
Measure the resistance.
Reinstall the ECU-IG fuse.
|
| ||||
| OK | |
| 4.CHECK HARNESS OR CONNECTOR (IG POWER SOURCE) |
![]() |
Disconnect the D26 theft warning ECU connector.
Turn the ignition switch ON.
Measure the voltage.
| Tester Connection | Specified Condition |
| D26-9 (IG) - Body ground | 11 to 14 V |
Reconnect the theft warning ECU connector.
|
| ||||
| OK | ||
| ||