THEFT DETERRENT SYSTEM (for Sedan) > Security Horn Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY HORN) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester main switch ON.
Select the item below in the Active Test and then check that the horn operate.
| Item | Test Details | Diagnostic Note |
| Security Horn | Security horn ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FUSE (ECU-B) |
![]() |
Remove the ECU-B fuse from the engine room R/B.
Measure the resistance.
Reinstall the ECU-B fuse.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY- BODY GROUND) |
![]() |
Disconnect the D26 theft warning ECU connector.
Measure the voltage.
| Tester Connection | Specified Condition |
| D26-13 (+B2) - Body ground | 11 to 14 V |
Reconnect the theft warning ECU connector.
|
| ||||
| OK | |
| 4.INSPECT SECURITY HORN ASSEMBLY |
![]() |
Disconnect the A23 security horn connector.
Check the operation of the security horn.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 (B) Battery negative (-) → Terminal 2 (L) | Security horn sounds |
Reconnect the security horn connector.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - SECURITY HORN ASSEMBLY) |
Disconnect the D26 theft warning ECU and the A23 security horn connectors.
![]() |
Measure the resistance.
| Tester Connection | Specified Condition |
| D26-15 (SH-) - A23-1 (B) | Below 1 Ω |
| A23-2 (L) - Body ground | Below 1 Ω |
| D26-15 (SH-) or A23-1 (B) - Body ground | 10 kΩ or higher |
Reconnect the theft warning ECU and the security horn connectors.
|
| ||||
| OK | ||
| ||