THEFT DETERRENT SYSTEM (for Sedan) > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester main switch ON.
Select the item below in the Active Test and then check that the security indicator operates.
| Item | Test Details | Diagnostic Note |
| Security Indicator | Security indicator light ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK SECURITY INDICATOR LIGHT ASSEMBLY |
![]() |
Disconnect the D25 security indicator light connector.
Apply battery voltage to the terminals of the security indicator and check the lighting condition.
| Measurement Condition | Specified Operation |
| Battery positive (+) - Terminal 2 Battery negative (-) - Terminal 6 | Indicator light comes on. |
Reconnect the indicator light connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - SECURITY INDICATOR LIGHT ASSEMBLY) |
![]() |
Disconnect the D26 theft warning ECU and the D25 security indicator light connectors.
Measure the resistance.
| Tester Connection | Specified Condition |
| D26-29 (IND) - D25-2 | Below 1 Ω |
| D26-29 (IND) - Body ground | 10 kΩ or higher |
Reconnect the theft warning ECU and the security indicator light connectors.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT ASSEMBLY - BODY GROUND) |
Disconnect the D25 security indicator light connector.
![]() |
Measure the resistance.
| Tester Connection | Specified Condition |
| D25-6 - Body ground | Below 1 Ω |
Reconnect the security indicator light connector.
|
| ||||
| OK | ||
| ||