Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (for Hatchback)

SEAT BELT WARNING SYSTEM (for Hatchback) > Driver Side Seat Belt Warning Light does not Operate


DESCRIPTION

When the ignition switch is ON, the airbag sensor assembly transmits front seat inner belt status signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver side seat belt warning light. If the seat belt is fastened, the warning light turns off.

WIRING DIAGRAM


B289096E05


B289096E06


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Clear the DTC (Click here.

  1. Recheck for DTCs.
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC OUTPUT (AIRBAG SYSTEM)
  1. Clear the DTC.

    1. for Hatchback with VSC (Click here)
    2. for Hatchback without VSC (Click here)

  1. Recheck for DTCs.
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for Hatchback with VSC)
    B
    DTC is output (for Hatchback without VSC)
    C



B
GO TO AIRBAG SYSTEM (Click here)

C
GO TO AIRBAG SYSTEM (Click here)
A


3.PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SIDE SEAT BELT)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF or ON
    Confirm that the vehicle is stopped with the engine idling

OK:
The driver side seat belt warning light on the combination meter assembly operates normally.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)