Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (for Hatchback)

SEAT BELT WARNING SYSTEM (for Hatchback) > Front Passenger Side Seat Belt Warning Light Malfunction


DESCRIPTION

The occupant classification ECU detects the state of the front seat inner belt assembly RH and load sensor when the front passenger side seat is occupied with the ignition switch ON. If the front passenger side seat belt is not fastened, the front passenger side seat belt warning light on the combination meter assembly blinks. If the seat belt is fastened, the warning light turns off.

WIRING DIAGRAM


B289097E08


B289097E09


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC OUTPUT (OCCUPANT CLASSIFICATION SYSTEM)
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO OCCUPANT CLASSIFICATION SYSTEM (Click here)
A


3.CHECK DTC OUTPUT (AIRBAG SYSTEM)
  1. Clear the DTC.

    1. for Hatchback with VSC (Click here)
    2. for Hatchback without VSC (Click here)

  1. Recheck for DTCs.
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for Hatchback with VSC)
    B
    DTC is output (for Hatchback without VSC)
    C



B
GO TO AIRBAG SYSTEM (Click here)

C
GO TO AIRBAG SYSTEM (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)