RADIO ANTENNA CORD (for Sedan) > INSTALLATION |
| 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Install the antenna cord positioning tapes into the 6 claws of the front and rear side rail spacers.

| *1 | Tape | *2 | Positioning Tape |
| *a | Marking | - | - |
| Mark | Measurement |
| a | 80 mm (3.15 in.) |
| b | 20 mm (0.787 in.) |
Align the antenna cord positioning tapes with the markings on the roof headlining.
Install the antenna cord onto the roof headlining with 6 new pieces of tape.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. INSTALL ANTENNA CORD SUB-ASSEMBLY |
Install the antenna cord with the 6 clamps.
Connect the antenna amplifier connector.
Insert the hook into the body hole and install the bracket with the bolt.
| 4. INSTALL STEREO OPENING COVER |
Install the stereo opening cover with the 4 screws.
| 5. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY |
Engage the 2 claws and 4 clips and install the instrument cluster finish panel center.
| 6. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY |