CURTAIN SHIELD AIRBAG ASSEMBLY (for Hatchback 5 Door) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE ROOF HEADLINING ASSEMBLY |
| 4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY |
![]() |
Using a thin-bladed screwdriver with its tip wrapped with protective tape, release the locking button.
| *1 | Protective Tape |
| *2 | Locking Button |
Disconnect the airbag connector.
![]() |
Using a clip remover, pull up the 6 pins.
| *1 | Pin |
| *2 | Clip |
| *3 | Airbag |
| *4 | Body Panel |
![]() |
Using needle-nose pliers, disengage each 2 claws to disconnect the 6 clips and curtain shield airbag from the body panel as shown in the illustration.
| *1 | Clip |
| *2 | Airbag |
| *3 | Body Panel |
![]() |
Remove the bolt.
![]() |
Disengage hook A in the direction shown in the illustration, then disengage hook B by sliding in the direction shown in the illustration, and remove the curtain shield airbag assembly.
| *1 | Hook A |
| *2 | Hook B |
Remove the 6 clips and 6 spacers from the curtain shield airbag assembly.