Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM (for Sedan LH Side)

FRONT LOWER SUSPENSION ARM (for Sedan LH Side) > INSTALLATION



1. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM
  1. Provisionally tighten the lower arm with the 2 bolts.



    C107513
  1. Install the lower arm to the steering knuckle with a new castle nut.

    Torque:
    98 N*m{ 1000 kgf*cm , 72 ft.*lbf }

    NOTICE:
    If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.

  1. Install a new clip.



2. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. STABILIZE SUSPENSION
  1. Lower the vehicle from the jack.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



4. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM


C107515E01
  1. Fully tighten the 2 bolts.

    Torque:
    Bolt A:
    137 N*m{ 1397 kgf*cm , 101 ft.*lbf }
    Bolt B:
    151 N*m{ 1540 kgf*cm , 111 ft.*lbf }



5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)