DTC C1511 Torque Sensor Circuit Malfunction |
DTC C1512 Torque Sensor Circuit Malfunction |
DTC C1513 Torque Sensor Circuit Malfunction |
DTC C1514 Torque Sensor Power Supply Abnormal |
DTC C1517 Torque Hold Abnormal |
| DTC No. | Detection Item | Trouble Area |
| C1511 | Torque sensor (TRQ1) signal error or stop |
|
| C1512 | Torque sensor (TRQ2) signal error or stop | |
| C1513 | Deviation between torque sensor TRQ1 and TRQ2 exceeds specified value | |
| C1514 | Torque sensor power source voltage error | |
| C1517 | Temporary control due to malfunction related to torque sensor continues for long time |

| 1.CHECK CONNECTOR CONNECTION CONDITION |
Check the installation condition of the torque sensor connector.
|
| ||||
| OK | |
| 2.INSPECT POWER STEERING ECU ASSEMBLY (TORQUE SENSOR OUTPUT) |
![]() |
Start the engine.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| c10-8 (TRQV) - c10-2 (TRQG) | Engine running | 4.5 to 5.5 V |
| *a | Component with harness connected (Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 3.INSPECT POWER STEERING ECU ASSEMBLY (TRQ1, TRQ2 VOLTAGE) |
![]() |
Start the engine.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| c10-9 (TRQ1) - c10-2 (TRQG) | Engine running, steering wheel not turned (without load) | 2.3 to 2.7 V |
| c10-9 (TRQ1) - c10-2 (TRQG) | Engine running, steering wheel turned to right with vehicle stopped | 2.5 to 3.8 V |
| c10-9 (TRQ1) - c10-2 (TRQG) | Engine running, steering wheel turned to left with vehicle stopped | 1.2 to 2.5 V |
| c10-1 (TRQ2) - c10-2 (TRQG) | Engine running, steering wheel not turned (without load) | 2.3 to 2.7 V |
| c10-1 (TRQ2) - c10-2 (TRQG) | Engine running, steering wheel turned to right with vehicle stopped | 1.2 to 2.5 V |
| c10-1 (TRQ2) - c10-2 (TRQG) | Engine running, steering wheel turned to left with vehicle stopped | 2.5 to 3.8 V |
| *a | Component with harness connected (Power Steering ECU Assembly) |
Calculate the difference between the measured TRQV*1 and the sum of the output values of the torque sensor 1 and torque sensor 2.
|
| ||||
| OK | ||
| ||