POWER STEERING SYSTEM (for Hatchback) > CALIBRATION |
| TORQUE SENSOR ZERO POINT CALIBRATION |
Inspection before calibration.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Calibrate the power steering ECU assembly. Enter the following menus: Chassis / EMPS / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG Power Supply | ECU power source voltage/ Min.: 0 V Max.: 20.1531 V | 11 to 14 V | Ignition switch ON |
Perform the torque sensor zero point calibration.
Set the steering wheel to the center point and align the front wheels straight ahead.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Calibrate the power steering ECU assembly. Enter the following menus: Chassis / EMPS / Utility / Torque Sensor Adjustment.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC C1515 is output. |
Click here
|
| DTC C1516 is output. |
Click here
|
| DTC C1534 is output. |
Click here
|
| DTC C1581 is output. |
Click here
|
| ASSIST MAP WRITING |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Enter the following menus: Chassis / EMPS / Utility / Signal Check.
Check for DTCs (Click here).