Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL (for Sedan)

CLUTCH PEDAL (for Sedan) > INSTALLATION



1. INSTALL NO. 1 CLUTCH PEDAL CUSHION


C115318
  1. Install the No. 1 clutch pedal cushion onto the clutch pedal.



2. INSTALL CLUTCH PEDAL BUSH


C115309E02
  1. Apply MP grease to 2 new bushes and collar.

  1. Install the 2 bushes and collar onto the clutch pedal.



3. INSTALL CLUTCH PEDAL PAD


4. INSTALL CLUTCH PEDAL SUB-ASSEMBLY


C115308
  1. Install the clutch pedal onto the clutch pedal support with the bolt and the nut.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    Install the bolt from the right side of the vehicle.



5. INSTALL CLUTCH PEDAL SPRING


6. INSTALL CLUTCH PEDAL STOPPER BOLT


C115317
  1. Install the clutch pedal stopper bolt so that its end touches the clutch pedal cushion.

    HINT:
    Tighten the lock nut to the specified torque when adjusting the clutch pedal.



7. INSTALL CLUTCH START SWITCH ASSEMBLY


C115315
  1. Install the clutch start switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }



8. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY


C115316
  1. Install the clutch pedal support onto the vehicle with the bolt.

    Torque:
    24 N*m{ 241 kgf*cm , 17 ft.*lbf }

  1. Connect the clutch start switch connector.

  1. Connect the wire harness clamp.



9. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY


    C115307
  1. Install the clutch master cylinder assembly with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



10. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


    C115313
  1. Using a union nut wrench, connect the flexible hose tube.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (Click here).



11. INSTALL CLUTCH RESERVOIR TUBE
  1. Connect the clutch reservoir tube with the clip to the clutch master cylinder assembly.



12. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


13. INSTALL BRAKE BOOSTER ASSEMBLY
(Click here)


14. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.



    C115306E03
  1. Check that the pedal height is correct.
    Text in Illustration 
    *a
    Pedal Height Adjust Point
    *b
    Pedal Height
    *c
    Push Rod Play And Free Play Adjust Point

    Pedal height from floor:
    133.0 to 143.0 mm (5.236 to 5.630 in.)

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }