Home › Drivetrain ยท CLUTCH › CLUTCH MASTER CYLINDER (for Sedan)

CLUTCH MASTER CYLINDER (for Sedan) > INSTALLATION



1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


    C247297E01
  1. Install the lock nut onto the push rod.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Push Rod Clevis

  1. Install the push rod clevis.

  1. Tighten the lock nut and check the dimension A is same as the dimension A that has been measured.



2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY


    C115307
  1. Install the clutch master cylinder assembly with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



3. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


    C115313
  1. Using a union nut wrench, connect the flexible hose tube.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (Click here).



4. INSTALL CLUTCH RESERVOIR TUBE
  1. Connect the clutch reservoir tube with the clip to the clutch master cylinder assembly.



5. INSTALL BRAKE BOOSTER ASSEMBLY
(Click here)


6. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.



    C115306E03
  1. Check that the pedal height is correct.
    Text in Illustration 
    *a
    Pedal Height Adjust Point
    *b
    Pedal Height
    *c
    Push Rod Play And Free Play Adjust Point

    Pedal height from floor:
    133.0 to 143.0 mm (5.236 to 5.630 in.)

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }