CLUTCH MASTER CYLINDER (for Hatchback) > REMOVAL |
| 1. REMOVE BRAKE BOOSTER ASSEMBLY |
| 2. REMOVE CLUTCH RESERVOIR TUBE |
![]() |
Slide the clip and remove the clutch reservoir tube from the clutch master cylinder assembly.
| 3. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench (10 mm), disconnect the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.
| 4. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY |
![]() |
Push the clutch master cylinder push rod clevis upward and release it toward the left side of the vehicle.
![]() |
Remove the 2 nuts and the clutch master cylinder assembly.
| 5. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS |
![]() |
Measure the dimension A as shown in the illustration before loosening the lock nut.
| *1 | Lock Nut |
| *2 | Clutch Master Cylinder Push Rod Clevis |
Loosen the lock nut and remove the clutch master cylinder push rod clevis from the push rod.
Remove the lock nut from the push rod.