Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for Hatchback)

BRAKE BOOSTER (for Hatchback) > REMOVAL


NOTICE:
Release the vacuum from booster by depressing the brake pedal several times.
Then remove the brake master cylinder from brake booster.



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



2. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


    B284273
  1. Disengage the 5 clips and the 2 claws and remove the instrument panel finish panel.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


    B284274
  1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


5. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
(Click here)


6. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


7. REMOVE PROPORTIONING VALVE ASSEMBLY (w/o ABS,VSC)
(Click here)


8. REMOVE BRAKE ACTUATOR ASSEMBLY (w/ ABS,VSC)
(Click here)


9. REMOVE FRONT NO. 1 VENTILATOR SEAL


C242062
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



10. REMOVE FRONT AIR SHUTTER SEAL RH

HINT:
Use the same procedure as for the No. 1 ventilator seal.



11. REMOVE INNER COWL TOP TO COWL BRACE


C242063
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



12. REMOVE OUTER COWL TOP PANEL


C242064
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    C242065



13. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


C233917
  1. Remove the brake pedal return spring.

  1. Remove the clip and push rod pin and separate the push rod clevis from the brake pedal.



14. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY


C234878E02
  1. Place matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen bolt A.

  1. Remove bolt B and separate the No. 2 steering intermediate shaft assembly from the steering column assembly.



15. REMOVE BRAKE BOOSTER ASSEMBLY


    C244842
  1. Slide the clip and disconnect the vacuum hose from the check valve.



    C241860
  1. Remove the 4 nuts and brake booster assembly.

    NOTICE:
    Do not damage the brake tubes.

  1. Remove the gasket from the brake booster assembly.