Home › Drivetrain ยท CLUTCH › CLUTCH UNIT (for Sedan)

CLUTCH UNIT (for Sedan) > REMOVAL



1. REMOVE MANUAL TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY
  1. Remove the clutch release fork with the clutch release bearing from the manual transaxle.



3. REMOVE CLUTCH RELEASE FORK BOOT


4. REMOVE CLUTCH RELEASE BEARING ASSEMBLY
  1. Remove the clutch release bearing from the clutch release fork.



5. REMOVE RELEASE BEARING HUB CLIP


6. REMOVE RELEASE FORK SUPPORT
  1. Remove the release fork support from the manual transaxle.



7. REMOVE CLUTCH COVER ASSEMBLY


    D025280E12
  1. Align the matchmark on the clutch cover assembly with the one on the flywheel.
    Text in Illustration 
    *a
    matchmarks

  1. Loosen each set bolt one turn at a time until the spring tension is released.

  1. Remove the set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



8. REMOVE CLUTCH DISC ASSEMBLY